Generac SE10000 Manuel du propriétaire télécharger pdf (Page 5)

Generac Portable Products SE10000 Generator

WHEEL KIT INSTALLATION

You will need a 13mm metric box, open end or socket

wrench to install this kit.

Install Wheel Kit as follows: (Figure 3)

1. Place the bottom of the generator cradle on a flat,

even surface. It may help to raise the cradle on

temporary blocks.

2. Slide axle through both axle mounting brackets on

cradle frame.

3. Slide spacer over each end of axle.

4. Install the wheel. Secure wheel on axle with

retaining pin and washer. Be sure to install the

wheel with the raised hub inboard.

5. Install other wheel in the same manner.

6. Secure the vibration mount on the support leg

with lock nut, washer, and 30mm capscrew.

Fasten the support leg to the bottom of the

generator cradle, using 20mm capscrews, lock

washers and flat washers.

7. Position the handle below the muffler bracket on

the engine side of the generator. Attach the

handle with 45mm capscrews and lock nuts.

8 Recheck all nuts to make sure they are tight and

secure. Remove the temporary blocks.

Figure 3  Wheel Kit

Handle

45mm Capscrew

M8 Flat

Washer

Vibration

Mount

Retaining Pin

Washer

Support Leg

Flat Washer

Lock Washer

Locking Nut

Locking

Nut

20mm Capscrew

Wheel

Spacer

Axle

30mm

Capscrew

1 2 3 4 5 6 7 8 9 10 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Generac SE10000 Manuel du propriétaire Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Générateurs d'électricité Generac SE10000